HSDL-3201#001 Lite-On Electronics, HSDL-3201#001 Datasheet - Page 14

• Manufacturer Part Number: HSDL-3201#001
• Description: Infrared Transceivers IR Transceiver 115.2Kb/s
• Manufacturer: Lite-On Electronics
• Type: TX/RXr
• Series: -r

Specifications of HSDL-3201#001

• Pulse Width: 1.6/2.45us
• Led Supply Voltage: 2.7 to 6V
• Dimensions: 8x3x2.5
• Peak Wavelength: 875/880nm
• Angle Of Half Sensitivity: 60/30°
• Communication Distance: 30
• Package Type: Ultra Small Profile
• Fall Time: 600/25ns
• Rise Time: 600/20ns
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Mounting: Surface Mount
• Pin Count: 9
• Operating Temp Range: -25C to 85C
• Operating Temperature Classification: Commercial
• Data Rate: 115.2Kbps
• Wavelength: 875 nm, 880 nm
• Continual Data Transmission: 115.2 Kbit/s
• Transmission Distance: 30 cm
• Radiant Intensity: 9 mW/sr
• Half Intensity Angle Degrees: 30 deg to 60 deg
• Maximum Rise Time: 120 ns, 600 ns
• Maximum Fall Time: 80 ns, 600 ns
• Operating Voltage: 2.7 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 25 C
• Package / Case: Ultra Small Profile
• Idle Current, Typ @ 25° C: 100µA
• Link Range, Low Power: 30cm
• Operating Temperature: -25°C ~ 85°C
• Orientation: Side View
• Shutdown: Yes
• Size: 8mm x 3mm x 2.5mm
• Standards: IrPHY 1.2
• Supply Voltage: 2.7 V ~ 3.6 V
• Lead Free Status / RoHS Status: Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Compliant

PCB Layout Suggestion
The following PCB layout shows a
recommended layout that should
result in good electrical and EMI
performance. Things to note:
1. The ground plane should be
2. The shield trace is a wide, low
3. The AGND pin is connected to the
4. C1 is an optional V
5. V
14
continuous under the part, but
should not extend under the
shield trace.
inductance trace back to the
system ground.
ground plane and not to the shield
tab.
capacitor; it may be left out if the
Vcc is clean.
unfiltered or unregulated power.
If C1 is used, and if V
connected to V
should be before the C1 cap.
LED
can be connected to either
CC
, the connection
CC
LED
filter
is
Component Side
Circuit Side
C1