5962-8866208UA QP SEMICONDUCTOR, 5962-8866208UA Datasheet - Page 12

• Manufacturer Part Number: 5962-8866208UA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-8866208UA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
NOTES:
1. WE must be high during all address transitions.
2. A write occurs during the overlap (t
3. t
4. During this period, the I/O pins are in the output state, and input signals must not be applied.
5. If the CE low transition occurs simultaneously with or after the WE low transition, the outputs remain in the high
6. Transition is measured ±500 mV from steady state with a 5 pF load (including scope and jig).
7. If OE is low during a WE controlled write cycle, the write pulse width must be the larger of t
impedance state.
+ t
controlled write cycle, this requirement does not apply and the write pulse can be as short as the specified t
WHAX
DVWH
DEFENSE SUPPLY CENTER COLUMBUS
is measured from the earlier of CE or WE going high to the end of the write cycle.
) to allow the I/O drivers to turn off and data to be placed on the bus for required t
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
ELWH
FIGURE 4. Timing waveforms - Continued.
or t
WLWH
) of a low CE and a low WE .
SIZE
A
REVISION LEVEL
D
DVWH
WLWH
. If OE is low during a WE
or (t
WLQZ
SHEET
5962-88662
WLWH
.
12