HA1-2425-5 Intersil, HA1-2425-5 Datasheet - Page 7

• Manufacturer Part Number: HA1-2425-5
• Manufacturer: Intersil

Specifications of HA1-2425-5

• Number Of Sample And Hold Elements: 1
• Acquisition Time: 6us
• Power Supply Requirement: Dual
• Single Supply Voltage (typ): Not RequiredV
• Single Supply Voltage (min): Not RequiredV
• Single Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): ±12V
• Dual Supply Voltage (max): ±15V
• Operating Temperature Classification: Commercial
• Mounting: Through Hole
• Pin Count: 14
• Lead Free Status / RoHS Status: Not Compliant

Glossary of Terms
Acquisition Time
The time required following a “sample” command, for the output
to reach its final value within ±0.1% or ±0.01%. This is the
minimum sample time required to obtain a given accuracy, and
includes switch delay time, slewing time and settling time.
Aperture Time
The time required for the sample-and-hold switch to open,
independent of delays through the switch driver and input
amplifier circuitry. The switch opening time is that interval
between the conditions of 10% open and 90% open.
FIGURE 9. GUARD RING LAYOUT (BOTTOM VIEW)
OUT
CAPACITOR
HOLD
GND
V+
CONTROL
7
-IN
+IN
V-
HA-2420, HA-2425
Effective Aperture Delay Time (EADT)
The difference between the digital delay time from the Hold
command to the opening of the S/H switch, and the
propagation time from the analog input to the switch.
EADT may be positive, negative or zero. If zero, the S/H
amplifier will output a voltage equal to V
Hold command was received. For negative EADT, the output in
Hold (exclusive of pedestal and droop errors) will correspond to
a value of V
Aperture Uncertainty
The range of variation in Effective Aperture Delay Time.
Aperture Uncertainty (also called Aperture Delay Uncertainty,
Aperture Time Jitter, etc.) sets a limit on the accuracy with
which a waveform can be reconstructed from sample data.
Drift Current
The net leakage current from the hold capacitor during the
hold mode. Drift current can be calculated from the droop
rate using the formula:
I
D
(pA)
=
C
IN
H
(pF)
that occurred before the Hold command.
×
∆V
------- -
∆t
(V s )
⁄
IN
at the instant the
November 19, 2004
FN2856.6