R0K5562T0S000BE Renesas Electronics America, R0K5562T0S000BE Datasheet - Page 13

• Manufacturer Part Number: R0K5562T0S000BE
• Description: KIT STARTER FOR RX62T
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K5562T0S000BE

• Design Resources: RX62T CPU Board Schematics
• Contents: Board, Cable, CD, Documentation, Emulator, Power Supply
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RX600 series

RSKRX62T
5.2
For this tutorial it is not necessary to provide an external power supply to the board. The power will be obtained
from the USB port. Please be aware that if you have too many devices connected to your USB port it may be shut
down by Windows. If this happens remove some devices and try again. Alternatively provide an external power
source taking care to ensure the correct polarity and voltage.
The Quick Start Guide provided with the Renesas Starter Kit board gives detailed instructions on how to connect
the E1 to the host computer. The following assumes that the steps in the Quick Start Guide have been followed and
the E1 drivers have been installed.
•
•
•
•
5.3
This section will take you through the process of connecting to the device, programming the Flash and executing
the code.
REJ10J2195-0100
Oct 10, 2010
Other sample code supplied with this RSK will require a variable power supply; in which case an external 5V variable
power supply should be used. Refer to the RSKRX62T User Manual for further details.
Please note that the “Emulator Mode” wizard shown here will only appear the FIRST time you connect to the target
within a project. On subsequent connections the “Emulator Setting” dialog will appear please choose the same options
to connect.
Fit the LCD module to LCD connector on the board, via the header marked ‘LCD’. Ensure all the pins of the
connector are correctly inserted in the socket.
Connect the E1 Debugger to a free USB port on your computer.
Connect the E1 Debugger to the target hardware ensuring that it is plugged into the connector marked ‘E1’.
If supplying external power to the board, it can be turned on now.
Connecting to the Target with the E1 Debugger
Connecting the Debugger
Rev. 1.00
5. Building the Tutorial Program
Page 13 of 28