CS5366-DQZR Cirrus Logic Inc, CS5366-DQZR Datasheet - Page 39

• Manufacturer Part Number: CS5366-DQZR
• Description: IC,A/D CONVERTER,HEX,24-BIT,QFP,48PIN
• Manufacturer: Cirrus Logic Inc

Specifications of CS5366-DQZR

• Number Of Bits: 24
• Sampling Rate (per Second): 216k
• Data Interface: Serial
• Number Of Converters: 1
• Power Dissipation (max): 830mW
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1549 - BOARD EVAL FOR CS5366 192KHZ ADC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS626F4
7. PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
Offset Error
Intrachannel Phase Deviation
Interchannel Phase Deviation
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made with
a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full scale. This
technique ensures that the distortion components are below the noise level and do not affect the measure-
ment. This measurement technique has been accepted by the Audio Engineering Society, AES17-199, and
the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels. The dynamic range is
specified with and without an A-weighting filter.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A. Specified using an A-weighting filter.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response at
1 kHz. Units in decibels.
A measure of crosstalk between one channel and all remaining channels, measured for each channel at the
converter's output with no signal to the input under test and a full-scale signal applied to all other channels.
Units in decibels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
The deviation of the mid-scale transition (111...111 to 000...000) from the ideal. Units in mV.
The deviation from linear phase within a given channel.
The difference in phase response between channels.
CS5366
39