AM29F032B-90ED Spansion Inc., AM29F032B-90ED Datasheet - Page 18

• Manufacturer Part Number: AM29F032B-90ED
• Description: Flash Memory IC
• Manufacturer: Spansion Inc.

Specifications of AM29F032B-90ED

• Memory Size: 1Mbit
• Memory Configuration: 4M X 8
• Ic Interface Type: Parallel
• Access Time: 90ns
• Memory Case Style: TSOP
• No. Of Pins: 40
• Operating Temperature Range: 0°C To +70°C
• Peak Reflow Compatible (260 C): Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

minates the time-out period and suspends the erase
operation.
After the erase operation has been suspended, the
system can read array data from or program data to
any sector not selected for erasure. (The device “erase
suspends” all sectors selected for erasure.) Normal
read and write timings and command definitions apply.
Reading at any address within erase-suspended sec-
tors produces status data on DQ7–DQ0. The system
can use DQ7, or DQ6 and DQ2 together, to determine
if a sector is actively erasing or is erase-suspended.
The Erase Resume command is valid only during the
Erase Suspend mode. See
sume Commands” on page 15
status bits.
After an erase-suspended program operation is com-
plete, the system can once again read array data within
non-suspended sectors. The system can determine
the status of the program operation using the DQ7 or
DQ6 status bits, just as in the standard program oper-
ation. See
mands” on page 15
The system may also write the autoselect command
sequence when the device is in the Erase Suspend
mode. The device allows reading autoselect codes
even at addresses within erasing sectors, since the
codes are not stored in the memory array. When the
device exits the autoselect mode, the device reverts to
the Erase Suspend mode, and is ready for another
valid operation. See
on page 14
The system must write the Erase Resume command
(address bits are “don’t care”) to exit the erase suspend
mode and continue the sector erase operation. Further
16
for more information.
“Erase Suspend/Erase Resume Com-
for more information.
“Autoselect Command Sequence”
“Erase Suspend/Erase Re-
for information on these
D A T A
Am29F032B
S H E E T
writes of the Resume command are ignored. Another
Erase Suspend command can be written after the de-
vice has resumed erasing.
Notes:
1. See the appropriate Command Definitions table for erase
2. See “DQ3: Sector Erase Timer” for more information.
command sequence.
No
Figure 3. Erase Operation
Command Sequence
Erasure Completed
Write Erase
from System
Data = FFh?
Data Poll
START
Yes
21610D5 November 2, 2006
Embedded
Erase
algorithm
in progress