STEVAL-MKI105V1 STMicroelectronics, STEVAL-MKI105V1 Datasheet - Page 13

• Manufacturer Part Number: STEVAL-MKI105V1
• Description: Power Management Modules & Development Tools LIS3DH Adapter Board Standard DIL 24
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-MKI105V1

• Product: Power Management Development Tools
• For Use With/related Products: MEMS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UM0979
4
4.1
4.2
Supported commands
The microcontroller mounted on the eMotion board is equipped with dedicated firmware that
supports a set of commands which allow to control either the digital or the analog output
MEMS sensor and permits the acquisition of the measured data. The firmware also handles
the communication between the board and the PC through the USB bus. These features
allow the user to easily write their own applications to exploit the capabilities of the sensor
chosen.
This section describes the commands that are supported by the firmware for the
microcontroller of the eMotion demonstration kit.
Getting started
Before using the commands supported by the firmware, the following procedure must be
performed:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Once this procedure has been completed the user can utilize the commands described in
the following sections by typing them into the “HyperTerminal” window.
Supported commands
The firmware supports a wide range of MEMS adapters; the next section reports the
complete list of supported commands (see
Then, split into sections, the list of commands available for each sensor supported by the
eMotion firmware is reported.
Connect the eMotion to the USB port
Launch an application which allows to send commands through the virtual serial port.
The remainder of this document assumes the use of “Microsoft
program available with the Windows XP operating system
Create a new connection, enter a name (e.g. “STEVAL-MKI0109V1”), and click “OK”
In the “Connect Using” field, select the virtual COM port to which the USB port has
been mapped, and click “OK”
In port settings, set bits per second to 115200, data bits to 8, parity to none, stop bits to
1, and flow control to none. Click “OK”
On the “HyperTerminal” application window choose “files” > “properties” > “settings”,
then click on the “ASCII Setup” button
Select “Send line ends with line feeds” and “Echo typed characters locally”
Click the “OK” button to close the “ASCII Setup” window
Click the “OK” button to close the “Properties” window.
Doc ID 17768 Rev 1
Table
3) and their description.
Supported commands
©
HyperTerminal”
13/32