5750833-1 TE Connectivity, 5750833-1 Datasheet - Page 4

• Manufacturer Part Number: 5750833-1
• Description: SCSI CONNECTOR, PLUG, 26POS, IDC/IDT
• Manufacturer: TE Connectivity
• Type: SCSIr
• Series: Amplimite 0.050r

Specifications of 5750833-1

• Number Of Terminals: 26
• Termination Method: IDT
• Body Orientation: Straight
• Gender: PL
• Number Of Ports: 1Port
• Pitch (mm): 1.27mm
• Number Of Contacts: 26POS
• Contact Plating: Gold Over Nickel
• Housing Material: Polyester
• Contact Material: Phosphor Bronze
• Mounting Style: Cable
• Operating Temp Range: -55C to 85C
• Current Rating (max): 1/ContactA
• Connector Type: SCSI
• No. Of Contacts: 26
• Contact Termination: IDC / IDT
• Connector Mounting: Cable
• Rohs Compliant: Yes
• Product Type: Connector
• Wire/cable Type: Round Jacketed Cable
• Mating Connector Lock: Without
• Detent: Without
• Rails: Without
• Termination Cover: With
• Product Series: Slimline
• Termination Method To Wire/cable: IDC
• Color: Black
• Shell Material: Steel
• Bracket Material: Zinc
• Panel Mount Retention: Without
• Bracket Plating: Nickel over Copper
• Shielded: Yes
• Solder Tail Contact Plating: Tin over Nickel
• Number Of Positions: 26
• Wire Range (mm [awg]): 0.08-0.09² [28]
• Shell Plating: Tin over Copper
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (30)
• Connector Style: Plug
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Cable
• Lead Free Status / RoHS Status: Compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall consist of a minimum of 5 connectors.
Test groups 1 and 2 shall be soldered to printed circuit boards. A minimum of 30 contacts from
these test groups shall be randomly selected and tested. If available, test group 1 shall contain
both minimum and maximum size connectors. Test groups 3 and 4 shall consist of a minimum of 5
unmated and unmounted connectors. A minimum of 24 contacts from test group 3 shall be
randomly selected and tested.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1393
4 of 6