843996-5 TE Connectivity, 843996-5 Datasheet - Page 3

• Manufacturer Part Number: 843996-5
• Description: TOOL, EXTRACTION RESET
• Manufacturer: TE Connectivity
• Type: Toolr

Specifications of 843996-5

• Lead Free Status / RoHS Status: RoHS Not Applicable

4. LOCKING LANCE RESET PROCEDURE
The tools described on this sheet are designed to
reposition depressed locking lances to ensure
retention in the housing. Check compatibility of the
contact and tool; then proceed as follows:
Rev
Front of
Housing
Tool
Stop
Insert
Tip Here
(Back of
Cavity)
3. Pull back lightly on the wire and, if necessary,
move tool just enough to release the lance.
4. Remove the contact from the housing; then
remove the tool.
(Figure 3, View C)
1. Orient the reset tip so the taper is facing the
locking lance.
2. Keep the reset tip flat against the receptacle box
and slide it toward the base of the locking lance
until it bottoms.
3. Remove tool tip and contact will be ready for
re–insertion into the housing.
C
Tools 843477-1, -2, -3, -4 and
Tools 843996-2, -3, -4
Top Release
Tool
Locking
Lance
Cavity
View A
Tool
Tip
Extraction/Lance Reset Tools 843477-[ ], and 843996-2, -3, -4, and -5
Flat Side
of Locking
Lance
Tip
Taper
Insert
Tip Here
(Side of
Cavity)
Figure 3
Tools 843477-5 and
843996-5
5. TOOL INSPECTION/MAINTENANCE
Tools 843477–[ ] and 843996–[ ] should conform to
the dimensions listed in Figure 4. It is recommended
that each tool be inspected upon its arrival to be sure
it has not been damaged in transit and at regularly
scheduled intervals to be sure it remains functional.
6. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
CAUTION
View B
S Update document to corporate requirements
S Changed reference product catalog from 65816
S Corrected dimensions in Figure 4 and table in
Side Release
Tool
to 1307819 in NOTE in Section 1,
INTRODUCTION; and in NOTE in Figure 2
Figure 4
Only
Damaged product should not be used. If a
damaged contact is evident, it should be cut from
the wire and replaced with a new one. If a
damaged housing is evident, it should be
replaced.
Edge of
Locking
Lance
Lance
Reset
Portion
Receptacle
Box (Typ)
View C
408-9453
Locking
Lance
3
of 4