SNAP-IT-PM-ADS-PLUS OPTO 22, SNAP-IT-PM-ADS-PLUS Datasheet - Page 9

• Manufacturer Part Number: SNAP-IT-PM-ADS-PLUS
• Description: Controllers
• Manufacturer: OPTO 22

Specifications of SNAP-IT-PM-ADS-PLUS

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Specifications
The following table lists specifications for SNAP-IT units.
LED Indicators
The following table describes system LEDs located on the top of the SNAP Ethernet or SNAP
Ultimate brain:
LEDs for Standard Digital I/O Modules
In addition to the system LEDs shown in the table above, numeric LEDs are also provided on each
standard digital module to indicate the status of its points. A lighted LED indicates that the digital
point is on. (High-density digital modules do not have status LEDs.)
SNAP-IT-PM
(all models)
Protocols
Ethernet Port
Serial Port
Modem
Power Supply
Power Consumption
Temperature
Humidity
100MB
10MB
ERD
LED
ACT
ETD
FD
Network Activity
Full Duplex Mode
Ethernet—Receive Data
Ethernet—Transmit Data
Ethernet Link Detection at 10 Mbps
Ethernet Link Detection at 100 Mbps
Standard enclosure meets NEMA 3R. NEMA 3 or NEMA 4 is
recommended for exterior use. Dimensions: 16.19" W, 18.25" H, 6.57" D
SNMP, SMTP, FTP, and Modbus/TCP over TCP/IP, UDP/IP, and PPP
10/100 Mbps Fast Ethernet, using Category 5 or superior solid UTP
cable with RJ-45 connector
RS-232. Default rate is 19,200 Kbd; baud rate is soft-selectable from
2400 to 115,200 Kbd.
V.34 (PLUS models only)
100–250 VAC (48 VDC and other options available by special order)
30 W
0° to 70° C operating
0–95% humidity, non-condensing
Description
Other Specifications
Communications
1267-050202—SNAP-IT-PM Installation Guide
Enclosure
RUN
SRD
LED
STD
3VF
5VF
FLT
Normal Operation
3 Volt Fault
5 Volt Fault
Microprocessor Fault
Serial—Receive Data
Serial—Transmit Data
Description
SPECIFICATIONS
9