SMBQS18AF BANNER ENGINEERING, SMBQS18AF Datasheet - Page 53

• Manufacturer Part Number: SMBQS18AF
• Description: Sensor Mounting Bracket
• Manufacturer: BANNER ENGINEERING

Specifications of SMBQS18AF

• For Use With: Banner Engineering QS 18 And QS18AF Series Sensors

NOTE: Retroreflective material has a pressure-sensitive adhesive. For maximum adhesion, surfaces must be clean and dry before applying. For best results, use full
†
*
BRT-THG-3X3-10
BRT-THG-4X4-5
BRT-THG-8.5X11-2
BRT-THG-18X36
BRT-THG-1-100
BRT-THG-2-100
BRT-THG-3-100
BRT-T-100
BRT-THT-100
BRT-TVHG2X2*
BRT-TVHG-8X10P
Retroreflective Tape
NOTE: Sensing range and signal strength at any given sensor-to-target distance will vary due to target reflectivity and target area. A “Reflectivity Factor” is
These targets are not recommended for polarized retroreflective sensors.
These are sealed micro-prism style pieces and may not be cut.
Suitable for use with Laser sensors, VS3 sensors and SME312LPC model sensors.
Not suggested for close range (less than 102 mm) except with VS3 sensors.
size; target may be trimmed as necessary.
Model
included for each target model to help predict sensor performance, relative to the excess gain curve plotted for target model BRT-3. Consider, also,
target area when predicting performance. Changing to a high reflectivity reflector (like BRT-92x92C) may also extend sensor range and/or reduce the
need for frequent reflector maintenance. A high reflectivity factor AND large surface area are needed for maximum range.
†
†
Reflectivity
Factor
0.07
0.2
0.8
0.8
0.7
0.7
0.7
0.7
0.7
0.7
0.7
Temperature
Maximum
175° C
60° C
60° C
60° C
60° C
60° C
60° C
60° C
65° C
60° C
60° C
203 x 254 mm
100 x 100 mm
216 x 280 mm
457 x 914 mm
75 x 75 mm
25 mm wide
50 mm wide
75 mm wide
25 mm wide
25 mm wide
50 x 50 mm
More information online at
Size
2.5 m length
2.5 m length
2.5 m length
2.5 m length
2.5 m length
Single sheet
10 per pack
5 per pack
2 per pack
4 per pack
1 per pack
Unit
bannerengineering.com
Reflectors
Accessories
401