A22S-C3M-11 Omron, A22S-C3M-11 Datasheet - Page 45

• Manufacturer Part Number: A22S-C3M-11
• Description: 22MM PUSHBUTTON
• Manufacturer: Omron
• Series: A22Sr
• Type: Standardr

Specifications of A22S-C3M-11

• Circuit: DPST (1-NO, 1-NC)
• Switch Function: 3 Position, Maintained
• Contact Rating @ Voltage: 10A @ 110VAC
• Illumination: Non-Illuminated
• Mounting Type: Panel Mount
• Termination Style: Screw Terminal
• Panel Cutout Dimensions: 22mm (Round)
• Contact Form: SPST
• Color: Black
• Actuator: Knob-Type Selector
• Number Of Positions: 3
• Number Of Poles Per Deck: 1
• Dielectric Strength: 1000 Volts
• Voltage Rating: 250 Volts
• Current Rating: 5 Amps
• Contact Rating: 5 Amps
• Current Rating (max): 5 Amps
• Voltage Rating Ac: 250 Volts
• Voltage Rating Dc: 30 Volts
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Illumination Type, Color: -
• Illumination Voltage (nominal): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: A22SC3M11

Using the Microload
Insert a contact protection circuit, if necessary, to prevent the
reduction of life expectancy due to extreme wear on the contacts
caused by loads where inrush current occurs when the contact is
opened and closed.
The minimum applicable load is the N-level reference value. This
value indicates the malfunction reference level for the reliability
level of 60% (λ 60) (conforming to JIS C5003).
The equation, λ 60 = 0.5 x 10
malfunction rate is less than 1/2,000,000 with a reliability level of
60%.
LEDs
The LED current-limiting resistor is built-in, so internal resistance
is not required.
If commercially available LEDs are used, select the ones that
meet the following conditions:
Base: BA9S/13j
Overall length: 26 mm max.
Power consumption: 2.6 W max.
Common To All Assemblies
Invalid
area
Microload area
General-purpose load area
Current (mA)
Area of use
- -4
/time indicates that the estimated
46
Others
The oil-resistant IP65 uses NBR rubber and is resistant to
general cutting oil and cooling oil. Some particular oils cannot be
used with the oil-resistant IP65, however, so contact your
OMRON representative for details.
If the panel is to be finished with coating, etc., make sure that the
panel meets the specified dimensions after the coating.
Do not subject the Switch to extreme shock or vibration. Doing so
will cause malfunctions and damage to the Switch.
Do not let sharp objects come into contact with the Switches that are
made of resin. Doing so will damage the Switches, causing
scratches on the outside of the Operational Units, and malfunction.
When handling the Switches, do not throw or drop them.
Hammer
Screwdriver
Common To All Assemblies
Do not allow the Switch
to drop and hit the
ground.
Do not place or drop
heavy objects on the
Switch.
Do not operate the Switch
with hard or sharp objects.