SA605DK/01,112 NXP Semiconductors, SA605DK/01,112 Datasheet - Page 8

• Manufacturer Part Number: SA605DK/01,112
• Description: IC MIXER FM IF SYSTEM LP 20-SSOP
• Manufacturer: NXP Semiconductors
• Series: SA605r
• Type: Mixersr

Specifications of SA605DK/01,112

• Package / Case: 20-SSOP
• Frequency: 0Hz ~ 500MHz
• Modulation Or Protocol: ASK, FSK
• Applications: FM Remote Receiver
• Current - Receiving: 5.7mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Features: RSSI Equipped
• Voltage - Supply: 4.5 V ~ 8 V
• Operating Temperature: -40°C ~ 85°C
• Supply Voltage (max): 8 V
• Supply Voltage (min): 4.5 V
• Supply Current: 5.7 mA
• Operating Temperature Range: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Memory Size: -
• Data Rate - Maximum: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-2087-5; 935275267112; SA605DK/01

1. C-message: The C-message filter has a peak gain of 100 for accurate measurements. Without the gain, the measurements may be af-
2. Ceramic filters: The ceramic filters can be 30kHz SFG455A3s made by Murata which have 30kHz IF bandwidth (they come in blue), or
3. RF generator: Set your RF generator at 45.000MHz, use a 1kHz modulation frequency and a 6kHz deviation if you use 16kHz filters, or
4. Sensitivity: The measured typical sensitivity for 12dB SINAD should be 0.22 V or -120dBm at the RF input.
5. Layout: The layout is very critical in the performance of the receiver. We highly recommend our demo board layout.
6. RSSI: The smallest RSSI voltage (i.e., when no RF input is present and the input is terminated) is a measure of the quality of the layout and
7. Supply bypass and shielding: All of the inductors, the quad tank, and their shield must be grounded. A 10-15 F or higher value tantalum
8. R5 can be used to bias the oscillator transistor at a higher current for operation above 45MHz. Recommended value is 22k , but should not
Philips Semiconductors
NOTES:
1997 Nov 07
High performance low power mixer FM IF system
fected by the noise of the scope and HP339 analyzer.
16kHz CFU455Ds, also made by Murata (they come in black). All of our specifications and testing are done with the more wideband filter.
8kHz if you use 30kHz filters.
design. If the lowest RSSI voltage is 250mV or higher, it means the receiver is in regenerative mode. In that case, the receiver sensitivity
will be worse than expected.
capacitor on the supply line is essential. A low frequency ESR screening test on this capacitor will ensure consistent good sensitivity in pro-
duction. A 0.1 F bypass capacitor on the supply pin, and grounded near the 44.545MHz oscillator improves sensitivity by 2-3dB.
be below 10k .
RF GENERATOR
45MHz
V
CC
Figure 5. SA605 Application Circuit Test Set Up
(+6)
DC VOLTMETER
8
RSSI
NE605 DEMO BOARD
SCOPE
AUDIO
HP339A DISTORTION
ANALYZER
C–MESSAGE
DATA
Product specification
SA605
SR00339