0600-00027 Laird Technologies, 0600-00027 Datasheet - Page 39

• Manufacturer Part Number: 0600-00027
• Description: ANTENNA 915MHZ 1/2WV 7" RPSMA
• Manufacturer: Laird Technologies

Specifications of 0600-00027

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 1
• Frequency: 902MHz ~ 928MHz
• Vswr: 2
• Gain: 2dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 8.25" (209.5mm)
• Impedance: 50 Ohms
• Technology Type: 1/2 Wave Wireless Transceiver Antenna
• Termination Style: RPSMA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Agency Compliancy Information
FCC / I
In general, there are two agency classifications of wireless applications; portable and mobile.
Portable – Portable is a classification of equipment where the user, in general, will be within 20cm of the transmitting antenna.
Portable equipment is further broken into two classes; within 2.5cm of human contact and beyond 2.5cm (NOTE: Ankles, feet,
wrists and hands are permitted to be within 2.5cm of the antenna even if the equipment is designated as being greater than 2.5cm).
The AC4790 is not agency approved for portable applications. The OEM is required to have additional testing performed to receive
this classification. Contact Aerocomm for details.
Mobile – Mobile defines equipment where the user will be 20cm or greater from the transmitting antenna. The antenna must be
mounted in such a way that it cannot be moved closer to the user with respect to the equipment, although the equipment may be
moved. NOTE: Ankles, feet, wrists and hands are permitted to be within 20cm of mobile equipment.
OEM Equipment Labeling Requirements
Antenna Requirements
WARNING:
WARNING:
WARNING:
NDUSTRY
requirements are met.
enclosure specifying the appropriate AeroComm FCC identifier for this product as well as the
FCC Notice below. The FCC identifiers are listed above in the Agency Identification Numbers
chart.
following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause
undesired operation.
When integrated in the OEMs product, these fixed antennas require professional installation
preventing end-users from replacing them with non-approved antennas. Any antenna not in
the previous table must be tested to comply with FCC Section 15.203 for unique antenna
connectors and Section 15.247 for emissions. Contact Aerocomm for assistance.
C
Caution: Any change or modification not expressly approved by AeroComm could void the
user’s authority to operate the equipment.
ANADA
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
This device complies with Part 15 of the FCC Rules. Operation is subject to the
This device has been tested with an MMCX connector with the antennas listed above.
(IC) R
EQUIREMENTS FOR
This includes a clearly visible label on the outside of the OEM
M
ODULAR
A
PPROVAL
39