NJM2860F3-25-TE1 NJR, NJM2860F3-25-TE1 Datasheet - Page 4

• Manufacturer Part Number: NJM2860F3-25-TE1
• Description: IC LDO REG 2.5V 100MA SC-88A
• Manufacturer: NJR
• Series: -r

Specifications of NJM2860F3-25-TE1

• Regulator Topology: Positive Fixed
• Voltage - Output: 2.5V
• Voltage - Input: Up to 14V
• Voltage - Dropout (typical): 0.1V @ 60mA
• Number Of Regulators: 1
• Current - Output: 130mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SC-70-5, SC-88A, SOT-323-5, SOT-353, 5-TSSOP
• Number Of Outputs: 1
• Polarity: Positive
• Input Voltage Max: 14 V
• Output Voltage: 2.5 V
• Output Type: Fixed
• Dropout Voltage (max): 0.18 V
• Output Current: 130 mA
• Line Regulation: 0.1 % / V
• Load Regulation: 0.03 % / mA
• Voltage Regulation Accuracy: 1 %
• Maximum Power Dissipation: 0.25 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Current - Limit (min): -
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Current - Limit (min): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: NJM2860F3-25TE1TR

2 In use of ON/OFF CONTROL:
1 In the case where ON/OFF Control is not required:
TYPICAL APPLICATION
Noise bypass Capacitance Cp
In the case of using a resistance "R" between V
Connect control terminal to V
State of control terminal:
Noise bypass capacitance Cp reduces noise generated by band-gap reference circuit. Noise level and
ripple rejection will be improved when larger Cp is used. Use of smaller Cp value may cause oscillation.
Use the Cp value of 0.01 F greater to avoid the problem.
The current flow into the control terminal while the IC is ON state (I
resistance "R" is inserted between V
The minimum control voltage for ON state (V
I
Temperature" characteristics. Therefore, the resistance "R" should be carefully selected to ensure the
control voltage exceeds the V
CONT
“H”
“L” or “open”
and the resistance "R". The I
output is enabled.
V
*5 Vo 2.6V version: Co=2.2 F
IN
V
IN
*5 Vo 2.6V version: Co=2.2 F
output is disabled.
0.1µF
0.1µF
(0 300k )
IN
CONT (ON)
terminal
R
R
CONT
IN
over the required temperature range.
and the control terminal.
is temperature dependence as shown in the "Control Current vs.
CONTROL
V
CONTROL
V
IN
IN
CONT (ON)
NJM2860
NJM2860
IN
GND
and control.
GND
) is increased due to the voltage drop caused by
NOISE
BYPASS
NOISE
BYPASS
V
V
OUT
OUT
CONT
1.0µF
Cp=0.01µF
) can be reduced when a pull up
1.0µF
Cp=0.01µF
*5
*5
V
V
OUT
OUT
NJM2860