OM6290 NXP Semiconductors, OM6290 Datasheet - Page 20

• Manufacturer Part Number: OM6290
• Description: DEMO BOARD LCD GRAPHIC DRIVER
• Manufacturer: NXP Semiconductors

Specifications of OM6290

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16/32-Bit
• Utilized Ic / Part: PCF2119, PCF8531, PCF8576
• Primary Attributes: Character, Graphic and Segment LCD Drivers
• Secondary Attributes: JTAG, I²C, UART & USB Interfaces
• Description/function: Demo Board
• Interface Type: USB, I2C, JTAG, UART
• Data Bus Width: 4 bit, 8 bit, 16 bit
• Operating Voltage: 1.8 V to 5.5 V
• For Use With/related Products: PCF8576DT, PCF2119S, PCF8531
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4703

Philips Semiconductors
After acknowledgement, one or more command bytes (m)
follow which define the status of the addressed PCF8576s.
The last command byte is tagged with a cleared most
significant bit, the continuation bit C. The command bytes
are also acknowledged by all addressed PCF8576s on the
bus.
After the last command byte, a series of display data bytes
(n) may follow. These display bytes are stored in the
display RAM at the address specified by the data pointer
and the subaddress counter. Both data pointer and
subaddress counter are automatically updated and the
data is directed to the intended PCF8576 device. The
acknowledgement after each byte is made only by the (A0,
A1 and A2) addressed PCF8576. After the last display
byte, the I
2001 Oct 02
handbook, full pagewidth
Universal LCD driver for low multiplex rates
2
C-bus master issues a STOP condition (P).
SDA
SCL
START condition
SDA
SCL
S
Fig.13 Definition of START and STOP conditions.
data valid
data line
stable;
Fig.12 Bit transfer.
20
allowed
change
of data
7.8
The command decoder identifies command bytes that
arrive on the I
continuation bit C in their most significant bit position
(Fig.17). When this bit is set, it indicates that the next byte
of the transfer to arrive will also represent a command. If
this bit is reset, it indicates the last command byte of the
transfer. Further bytes will be regarded as display data.
The five commands available to the PCF8576 are defined
in Table 4.
Command decoder
2
C-bus. All available commands carry a
STOP condition
MBA607
P
MBC622
SDA
SCL
Product specification
PCF8576