OM6290 NXP Semiconductors, OM6290 Datasheet - Page 38

• Manufacturer Part Number: OM6290
• Description: DEMO BOARD LCD GRAPHIC DRIVER
• Manufacturer: NXP Semiconductors

Specifications of OM6290

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16/32-Bit
• Utilized Ic / Part: PCF2119, PCF8531, PCF8576
• Primary Attributes: Character, Graphic and Segment LCD Drivers
• Secondary Attributes: JTAG, I²C, UART & USB Interfaces
• Description/function: Demo Board
• Interface Type: USB, I2C, JTAG, UART
• Data Bus Width: 4 bit, 8 bit, 16 bit
• Operating Voltage: 1.8 V to 5.5 V
• For Use With/related Products: PCF8576DT, PCF2119S, PCF8531
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4703

NXP Semiconductors
PCF2119X
Product data sheet
10.2.3.3 Icon_ctl
Table 25.
The PCF2119x can drive up to 160 icons. See
icon mapping.
Bit IM: When bit IM = 0, the chip is in character mode. In the character mode characters
and icons are driven (multiplex drive mode 1:18 or 1:9). The V
produces the V
When bit IM = 1, the chip is in icon mode. In the icon mode only the icons are driven
(multiplex drive mode 1:2). The V
programmed with register V
Table 26.
Bit IB: Icon blink control is independent of the cursor/character blink function.
When bit IB = 0, the icon blink is disabled. Icon data is stored in CGRAM character 0 to 3
(4 × 8 × 5 = 160 bits for 160 icons).
When bit IB = 1, the icon blink is enabled. In this case each icon is controlled by two bits.
Blink consists of two half phases (corresponding to the cursor on and off phases called
even and odd phases hereafter).
Icon states for the even phase are stored in CGRAM characters 0 to 3
(4 × 8 × 5 = 160 bits for 160 icons). These bits also define icon state when icon blink is not
used (see
Icon states for the odd phase are stored in CGRAM character 4 to 7 (another 160 bits for
the 160 icons). When icon blink is disabled CGRAM characters 4 to 7 may be used as
normal CGRAM characters.
Bit
RS
R/W
7 to 3
2
1
0
Bit IM
0
1
Symbol
-
-
-
IM
IB
DM
Mode
character mode
icon mode
Table
Icon_ctl bit description
Normal/icon mode operation
LCDOUT
All information provided in this document is subject to legal disclaimers.
27).
voltage programmed with register V
Value
0
0
00001
0
1
0
1
0
1
Rev. 9 — 14 April 2011
B
.
LCD
generator, if used, produces the V
Description
see
fixed value
icon mode
icon blink
direct mode
character mode, full display
icon mode, only icons displayed
icon blink disabled
icon blink enabled
off
on
Table 10
Figure 22
V
generated from V
generated from V
LCDOUT
and
A
.
Figure 23
LCD
LCD controllers/drivers
A
B
generator, if used,
PCF2119x
© NXP B.V. 2011. All rights reserved.
LCDOUT
for CGRAM to
voltage as
38 of 83