OM6290 NXP Semiconductors, OM6290 Datasheet - Page 20

• Manufacturer Part Number: OM6290
• Description: DEMO BOARD LCD GRAPHIC DRIVER
• Manufacturer: NXP Semiconductors

Specifications of OM6290

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16/32-Bit
• Utilized Ic / Part: PCF2119, PCF8531, PCF8576
• Primary Attributes: Character, Graphic and Segment LCD Drivers
• Secondary Attributes: JTAG, I²C, UART & USB Interfaces
• Description/function: Demo Board
• Interface Type: USB, I2C, JTAG, UART
• Data Bus Width: 4 bit, 8 bit, 16 bit
• Operating Voltage: 1.8 V to 5.5 V
• For Use With/related Products: PCF8576DT, PCF2119S, PCF8531
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-4703

NXP Semiconductors
9. Instructions
PCF8531
Product data sheet
9.1 Reset
Only two PCF8531 registers, the instruction register and the data register can be directly
controlled by the MPU. Before internal operation, control information is stored temporarily
in these registers to allow interfacing to various types of MPUs which operate at different
speeds or to allow interfacing to peripheral control ICs. The PCF8531 operation is
controlled by the instructions given in
Instructions are of four types:
In normal mode instructions which perform data transfer to/from the internal RAM are
used most frequently. Automatic incrementing by 1 of internal RAM addresses after each
data write reduces the MPU program load.
After reset or internal Power-On Reset (POR) (depending on the application), the LCD
driver is set to the following state:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Those that define PCF8531 functions e.g. display configuration, etc.
Those that set internal RAM addresses
Those that perform data transfer to/from the internal RAM
Others
Power-down mode (PD = 1)
Horizontal addressing (V = 0)
Display blank (D = 0; E = 0), no icon mode (IM = 0)
Address counter X[6:0] = 0; Y[2:0] = 0
Bias system BS[2:0] = 0
Multiplex rate M[1:0] = 0 (multiplex rate 1:17)
Temperature control mode TC[2:0] = 0
HV-gen control, HVE = 0 the high voltage (HV) generator is switched off, PRS = 0 and
S[1:0] = 0
V
RAM data is undefined
Command page definition H[1:0] = 0
LCD
= 0 V
All information provided in this document is subject to legal disclaimers.
Rev. 05 — 10 August 2010
Table
11.
34 x 128 pixel matrix driver
PCF8531
© NXP B.V. 2010. All rights reserved.
20 of 51