LTC3546IUFD#PBF Linear Technology, LTC3546IUFD#PBF Datasheet - Page 13

• Manufacturer Part Number: LTC3546IUFD#PBF
• Description: IC BUCK SYNC ADJ 1A/2A DL 28QFN
• Manufacturer: Linear Technology
• Type: Step-Down (Buck)r

Specifications of LTC3546IUFD#PBF

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 2
• Voltage - Output: 0.6 ~ 5 V
• Current - Output: 1A, 2A
• Frequency - Switching: 2.25MHz, 0.75MHz ~ 4MHz
• Voltage - Input: 2.25 ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 28-QFN
• Dc To Dc Converter Type: Step Down
• Pin Count: 28
• Input Voltage: 5.5V
• Output Voltage: 0.6 to 5V
• Switching Freq: 750 TO 4000/2900KHz
• Output Current: 2A
• Efficiency: 96%
• Package Type: QFN EP
• Output Type: Adjustable
• Switching Regulator: Yes
• Load Regulation: 0.2%
• Line Regulation: 0.2%/V
• Mounting: Surface Mount
• Input Voltage (min): 2.25V
• Operating Temperature Classification: Automotive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Compliant

OPERATION
The output capacitor and the inductor supply the power
to the load until I
and the main control loop which starts another cycle.
The Burst Mode peak inductor current can be set externally
via the BMC pin. When this pin is set somewhere between
0V to 0.6V, the voltage on this pin controls the Burst Mode
clamp level. When the BMC pin is pulled to V
Burst Mode clamp level is used.
For lower output voltage ripple at low currents, pulse-
skipping mode can be used. In this mode, the LTC3546
continues to switch at constant frequency down to very low
currents, where it will eventually begin skipping pulses.
Finally, in forced continuous mode, the inductor current
is constantly cycled which creates a fi xed output voltage
ripple at all output current levels. This feature is desirable in
telecommunications since the noise is a constant frequency
and is thus easy to fi lter out. Another advantage of this mode
is that the regulator is capable of both sourcing current into
a load and sinking some current from the output. In forced
TH
exceeds 0.31V, turning on the switch
IN
, an internal
continuous operation, an overvoltage comparator monitors
the V
overvoltage condition is detected (V
The SYNC/MODE pin selects what mode the LTC3546 is in.
The SYNC/MODE pin sets the mode for both regulators.
Dropout Operation
When the input supply voltage decreases toward the
output voltage, the duty cycle increases to 100% which
is the dropout condition. In the dropout condition, the
PMOS switch is turned on continuously with the output
voltage being equal to the input voltage minus the volt-
age drops across the internal P-channel MOSFETs and
inductors.
Low Supply Operation
The LTC3546 incorporates an undervoltage lockout circuit
which shuts down the part when the input voltage drops
below about 2.14V to prevent unstable operation.
FB
pin and decreases the current limit whenever an
FB
> 0.63V).
LTC3546
13
3546fb