LM83CIMQAX/NOPB National Semiconductor, LM83CIMQAX/NOPB Datasheet - Page 18

• Manufacturer Part Number: LM83CIMQAX/NOPB
• Description: IC TEMP SENSOR DIGITAL 16-SSOP
• Manufacturer: National Semiconductor

Specifications of LM83CIMQAX/NOPB

• Function: Hardware Monitor
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: External & Internal
• Sensing Temperature: -40°C ~ 125°C, External Sensor
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: No
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 16-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *LM83CIMQAX; *LM83CIMQAX/NOPB; LM83CIMQAX

www.national.com
4.0 Application Hints
6. Avoid running diode traces close to or parallel to high
7. If it is necessary to cross high speed digital traces, the
8. The ideal place to connect the LM83’s GND pin is as
9. Leakage current between D+ and GND should be kept
4.0 Typical Applications
speed digital and bus lines. Diode traces should be kept
at least 2cm. apart from the high speed digital traces.
diode traces and the high speed digital traces should
cross at a 90 degree angle.
close as possible to the Processors GND associated
with the sense diode. For the Pentium II this would be
pin A14.
to a minimum. One nano-ampere of leakage can cause
as much as 1˚C of error in the diode temperature read-
ing. Keeping the printed circuit board as clean as pos-
sible will minimize leakage current.
(Continued)
FIGURE 11. LM83 Demo Board Diode Layout
18
Noise coupling into the digital lines greater than 300mVp-p
(typical hysteresis), overshoot greater than 500mV above
V
vent successful SMBus communication with the LM83. SM-
Bus no acknowledge is the most common symptom, causing
unnecessary traffic on the bus. Although, the SMBus maxi-
mum frequency of communication is rather low (100kHz
max) care still needs to be taken to ensure proper termina-
tion within a system with multiple parts on the bus and long
printed circuit board traces. An R/C lowpass filter with a 3db
corner frequency of about 40MHz has been included on the
LM83’s SMBCLK input. Additional resistance can be added
in series with the SMBData and SMBCLK lines to further
help filter noise and ringing. Minimize noise coupling by
keeping digital traces out of switching power supply areas as
well as ensuring that digital lines containing high speed data
communications cross at right angles to the SMBData and
SMBCLK lines.
CC
, and undershoot less than 500mV below GND, may pre-
FIGURE 10. Ideal Diode Trace Layout
DS101058-22
DS101058-17