C8051F330DR Silicon Labs, C8051F330DR Datasheet - Page 105

• Manufacturer Part Number: C8051F330DR
• Description: 8-bit Microcontrollers - MCU 8kB 10ADC
• Manufacturer: Silicon Labs

Specifications of C8051F330DR

• Product Category: 8-bit Microcontrollers - MCU
• Core: 8051
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 8 KB
• Data Ram Size: 768 B
• On-chip Adc: No
• Operating Supply Voltage: 2.7 V to 3.6 V
• Package / Case: QFN-20
• Mounting Style: SMD/SMT
• Data Rom Size: 128 B
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 17
• Number Of Timers: 4
• On-chip Dac: No
• Processor Series: C8051
• Program Memory Type: Flash
• Factory Pack Quantity: 1500
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.7 V

C8051F330/1/2/3/4/5
11.4.3. System Clock
Additional Flash recommendations and example code can be found in AN201, "Writing to Flash from Firm-
ware", available from the Silicon Laboratories web site.
108
Bits7–2: UNUSED: Read = 000000b, Write = don’t care.
Bit1:
Bit0:
Bit7
—
R
10. Make certain that the Flash write and erase pointer variables are not located in XRAM. See
11. Add address bounds checking to the routines that write or erase Flash memory to ensure that
12. If operating from an external crystal, be advised that crystal performance is susceptible to
13. If operating from the external oscillator, switch to the internal oscillator during Flash write or
viced in priority order after the Flash operation has been completed and interrupts have been
re-enabled by software.
your compiler documentation for instructions regarding how to explicitly locate variables in dif-
ferent memory areas.
a routine called with an illegal address does not result in modification of the Flash.
electrical interference and is sensitive to layout and to changes in temperature. If the system
is operating in an electrically noisy environment, use the internal oscillator or use an external
CMOS clock.
erase operations. The external oscillator can continue to run, and the CPU can switch back to
the external oscillator after the Flash operation has completed.
PSEE: Program Store Erase Enable
Setting this bit (in combination with PSWE) allows an entire page of Flash program memory
to be erased. If this bit is logic 1 and Flash writes are enabled (PSWE is logic 1), a write to
Flash memory using the MOVX instruction will erase the entire page that contains the loca-
tion addressed by the MOVX instruction. The value of the data byte written does not matter.
0: Flash program memory erasure disabled.
1: Flash program memory erasure enabled.
PSWE: Program Store Write Enable
Setting this bit allows writing a byte of data to the Flash program memory using the MOVX
write instruction. The Flash location should be erased before writing data.
0: Writes to Flash program memory disabled.
1: Writes to Flash program memory enabled; the MOVX write instruction targets Flash
memory.
SFR Definition 11.1. PSCTL: Program Store R/W Control
Bit6
—
R
Bit5
—
R
Bit4
—
R
Rev. 1.7
Bit3
—
R
Bit2
—
R
PSEE
R/W
Bit1
SFR Address:
PSWE
R/W
Bit0
0x8F
00000000
Reset Value