E5CK OMRON [Omron Electronics LLC], E5CK Datasheet - Page 11

• Manufacturer Part Number: E5CK
• Description: Advanced, Compact Digital Controllers
• Manufacturer: OMRON [Omron Electronics LLC]

Operation
I Parameter Operation List
Switching to modes other than manual or protect mode is carried out using mode selection in the menu display.
The figure below shows all parameters in the order that they are displayed. Some parameters are not displayed depending on the protect mode
setting and conditions of use.
I Parameters and Menus
Note: For more details on the functions of each part and display contents, refer to the E5CK User’s Manual (H78).
Protect Mode
Manual Mode
Level 0 Mode
Level 1 Mode
Level 2 Mode
Setup Mode
Expansion Mode
Option Mode
Calibration Mode
Limits use of the menu and A/M Keys. The protect function prevents unwanted modification of parameters and
switching between the auto and manual operation.
The Controller can be switched to manual operation. The manipulated variable can be manipulated manually only
in this mode.
Set the Controller to this mode during normal operation. In this mode, change the set point during operation, and
start or stop Controller operation. The process value, SP ramp, and manipulated variable can only be monitored
in this mode.
The main mode for adjusting control. In this mode, execute AT (auto-tuning), and set alarm values, the control pe-
riod, and PID parameters.
The auxiliary mode for adjusting control. In this mode, set the parameters for limiting the manipulated variable and
set point, switch between the remote and local modes, and set the loop break alarm (LBA), alarm hysteresis, and
the digital filter value of inputs.
The mode for setting the basic specifications. In this mode, set parameters that must be checked or set before
operation such as the input type, scaling, output assignments and direct/reverse operation.
The mode for setting expanded functions. In this mode, set ST (self-tuning), SP setting limiter, select advanced
PID or ON/OFF control, specify the standby sequence resetting method, initialize parameters, and set the time for
automatic return to the monitoring display.
The mode for setting option functions. Select this mode only when the Option Unit is set in the Controller. In this
mode, set the communications conditions, transfer output and event input parameters to match the type of Option
Unit set in the Controller.
The mode for calibrating inputs and transfer output.
When calibrating input, the selected input type is calibrated. Whereas, transfer output can be calibrated only when
the Communications Unit (E53-CKF) is set in the Controller.
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
Expansion mode
Calibration mode
Option mode
Level 0 mode
Level 1 mode
Level 2 mode
Setup mode
Power ON
1 second min.
Parameters in a mode can be
switched by the Display Key. The
parameter following the last param-
eter is the top parameter.
A/M
A/M
1 second min.
+
Digital Controller
Protect mode
Manual mode
1 second min.
A/M
1 second min.
A/M
A/M
1 second min.
+
+
E5CK
I-73