h8s-2172 Renesas Electronics Corporation., h8s-2172 Datasheet - Page 430

• Manufacturer Part Number: h8s-2172
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family H8s-2100 Series
• Manufacturer: Renesas Electronics Corporation.

Erasure Execution: When flash memory is erased, the erase-block number on the user MAT
must be passed to the erasing program which is downloaded. This is set to the FEBS parameter
(general register ER0).
One block is specified from the block number 0 to 11.
For details on the erasing processing procedure, see section 14.4.2, User Program Mode.
a Flash erase block select parameter (FEBS: general register ER0 of CPU)
This parameter specifies the erase-block number. The several block numbers cannot be specified.
Rev. 2.00, 03/04, page 398 of 534
Bit
1
0
Bit Name
WA
SF
Initial
Value


R/W
R/W
R/W
Description
Write Address Error Detect
When the following items are specified as the start
address of the programming destination, an error
occurs.
•
•
0: Setting of programming destination address is normal
1: Setting of programming destination address is
Success/Fail
Indicates whether the program processing is ended
normally or not.
0: Programming is ended normally (no error)
1: Programming is ended abnormally (error occurs)
abnormal
When the programming destination address in the
area other than flash memory is specified
When the specified address is not in a 128-byte
boundary. (The lower eight bits of the address are
other than H'00 and H'80.)