ps710el-1a-e4 California Eastern Laboratories, ps710el-1a-e4 Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/1/118/california_eastern_laboratories_sml.jpg)
ps710el-1a-e4
Manufacturer Part Number
ps710el-1a-e4
Description
Optocouplers & Ssrs 6-pin Dip, 0.08 ? Low On-state Resistance 2.0 A Continuous Load Current 1-ch Optical Coupled Mos Fet
Manufacturer
California Eastern Laboratories
Datasheet
1.PS710EL-1A-E4.pdf
(12 pages)
RECOMMENDED SOLDERING CONDITIONS
(1) Infrared reflow soldering
(2) Wave soldering
(3) Cautions
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Fluxes
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10127EJ01V0DS
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
PS710E-1A,PS710EL-1A
260˚C MAX.
220˚C
11