w83877atd Winbond Electronics Corp America, w83877atd Datasheet - Page 130

• Manufacturer Part Number: w83877atd
• Description: Winbond I/o
• Manufacturer: Winbond Electronics Corp America

8.2.25 Configuration Register 19 (CR19), default=00H
When the device is in Extended Function mode and EFIR is 19H, the CR19 register can be accessed
through EFDR. The bit definitions are as follows:
This register is used for the high speed modem application. While the bit is set to logic 1, it can
increase the baudrate of UART to 921.2KBPS (the clock source of UART is 14.769MHz) for high
speed transmit/receive.
Bit 7 - bit 2: Reserved.
FASTA (Bit 1):
FASTB (Bit 0):
8.2.26 Configuration Register 20 (CR20)
When the device is in Extended Function mode and EFIR is 20H, the CR20 register can be accessed
through EFDR. Default = FCH if CR16 bit 2 = 1; default = 00H if CR16 bit 2 = 0. The bit definitions
are as follows:
This register is used to select the base address of the Floppy Disk Controller (FDC) from 100H-3F0H
on 16-byte boundaries. NCS = 0 and A10 = 0 are required to access the FDC registers. A[3:0] are
always decoded as 0xxxb.
FDCAD7-FDCAD2 (Bit 7-bit 2): match A[9:4]. Bit 7 = 0 and bit 6 = 0 disable this decode.
Bit 1-bit 0: Reserved, fixed at zero.
8.2.27 Configuration Register 23 (CR23)
0
1
0
1
7
6
the clock source of UART A is the same as the frequency of TURA (CR0C bit 7)
and SUAMIDI (CR3 bit 1) selected.
the clock source of UART A is 14.769MHZ.
the clock source of UART B is the same as the frequency of TURB (CR0C bit 6)
and SUBMIDI (CR3 bit 0) selected.
the clock source of UART B is 14.769MHZ.
5
7
4
6
3
5
2
4
1
3
0
- 126 -
2
FASTB
FASTA
reserved
reserved
reserved
reserved
reserved
reserved
1
0
reserved
reserved
FDCAD2
FDCAD3
FDCAD4
FDCAD5
FDCAD6
FDCAD7
Publication Release Date: April 1998
W83877ATF
Version 0.51