LPC2292_2294 NXP Semiconductors, LPC2292_2294 Datasheet - Page 2

• Manufacturer Part Number: LPC2292_2294
• Description: The LPC2292/2294 microcontrollers are based on a 16/32-bit ARM7TDMI-S CPU withreal-time emulation and embedded trace support, together with 256 kB of embeddedhigh-speed flash memory
• Manufacturer: NXP Semiconductors

NXP Semiconductors
3. Ordering information
LPC2292_2294
Product data sheet















Table 1.
Type number
LPC2292FBD144/01
LPC2292FET144/00
LPC2292FET144/01
LPC2292FET144/G
16 kB on-chip static RAM and 256 kB on-chip flash program memory. 128-bit wide
interface/accelerator enables high-speed 60 MHz operation.
In-System Programming/In-Application Programming (ISP/IAP) via on-chip bootloader
software. Single flash sector or full chip erase in 400 ms and programming of 256 B in
1 ms.
EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with the
on-chip RealMonitor software as well as high-speed real-time tracing of instruction
execution.
Two/four (LPC2292/2294) interconnected CAN interfaces with advanced acceptance
filters. Additional serial interfaces include two UARTs (16C550), Fast I
(400 kbit/s) and two SPIs.
Eight channel 10-bit ADC with conversion time as low as 2.44 s.
Two 32-bit timers (with four capture and four compare channels), PWM unit (six
outputs), Real-Time Clock (RTC), and watchdog.
Vectored Interrupt Controller (VIC) with configurable priorities and vector addresses.
Configurable external memory interface with up to four banks, each up to 16 MB and
8/16/32-bit data width.
Up to 112 general purpose I/O pins (5 V tolerant). Up to nine edge/level sensitive
external interrupt pins available.
60 MHz maximum CPU clock available from programmable on-chip PLL with settling
time of 100 s.
The on-chip crystal oscillator should have an operating range of 1 MHz to 25 MHz.
Power saving modes include Idle and Power-down.
Processor wake-up from Power-down mode via external interrupt.
Individual enable/disable of peripheral functions for power optimization.
Dual power supply:


CPU operating voltage range of 1.65 V to 1.95 V (1.8 V  0.15 V).
I/O power supply range of 3.0 V to 3.6 V (3.3 V  10 %) with 5 V tolerant I/O pads.
Ordering information
All information provided in this document is subject to legal disclaimers.
16/32-bit ARM microcontrollers with external memory interface
Package
Name
LQFP144
TFBGA144 plastic thin fine-pitch ball grid array package;
TFBGA144 plastic thin fine-pitch ball grid array package;
TFBGA144 plastic thin fine-pitch ball grid array package;
Rev. 8 — 8 June 2011
Description
plastic low profile quad flat package;
144 leads; body 20  20  1.4 mm
144 balls; body 12  12  0.8 mm
144 balls; body 12  12  0.8 mm
144 balls; body 12  12  0.8 mm
LPC2292/2294
© NXP B.V. 2011. All rights reserved.
2
C-bus
Version
SOT486-1
SOT569-2
SOT569-2
SOT569-2
2 of 54