ATtiny25 Atmel Corporation, ATtiny25 Datasheet - Page 19

• Manufacturer Part Number: ATtiny25
• Manufacturer: Atmel Corporation

Specifications of ATtiny25

• Flash (kbytes): 2 Kbytes
• Pin Count: 8
• Max. Operating Frequency: 20 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 4
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 6
• Ext Interrupts: 6
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 0.12
• Eeprom (bytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 105
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 5
• Pwm Channels: 6
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

8. Errata
8.1
8.1.1
8.1.2
8.1.3
8.2
8.2.1
8.2.2
2586NS–AVR–04/11
Errata ATtiny25
Errata ATtiny45
Rev D and E
Rev B and C
Rev A
Rev F and G
Rev D and E
The revision letter in this section refers to the revision of the ATtiny25 device.
No known errata.
•
1. EEPROM read may fail at low supply voltage / low clock frequency
Not sampled.
The revision letter in this section refers to the revision of the ATtiny45 device.
No known errata
•
1. EEPROM read may fail at low supply voltage / low clock frequency
EEPROM read may fail at low supply voltage / low clock frequency
EEPROM read may fail at low supply voltage / low clock frequency
Trying to read EEPROM at low clock frequencies and/or low supply voltage may result in
invalid data.
Problem Fix/Workaround
Do not use the EEPROM when clock frequency is below 1MHz and supply voltage is below
2V. If operating frequency can not be raised above 1MHz then supply voltage should be
more than 2V. Similarly, if supply voltage can not be raised above 2V then operating fre-
quency should be more than 1MHz.
This feature is known to be temperature dependent but it has not been characterised.
Guidelines are given for room temperature, only.
Trying to read EEPROM at low clock frequencies and/or low supply voltage may result in
invalid data.
Problem Fix/Workaround
Do not use the EEPROM when clock frequency is below 1MHz and supply voltage is below
2V. If operating frequency can not be raised above 1MHz then supply voltage should be
more than 2V. Similarly, if supply voltage can not be raised above 2V then operating fre-
quency should be more than 1MHz.
This feature is known to be temperature dependent but it has not been characterised.
Guidelines are given for room temperature, only.
ATtiny25/45/85
19