ATmega32 Atmel Corporation, ATmega32 Datasheet - Page 16

• Manufacturer Part Number: ATmega32
• Manufacturer: Atmel Corporation

Specifications of ATmega32

• Flash (kbytes): 32 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 32
• Ext Interrupts: 3
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 2
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 4
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

ATmega32
Memories
In-System
Reprogrammable
Flash Program
Memory
2503Q–AVR–02/11
This section describes the different memories in the Atmel
ture has two main memory spaces, the Data Memory and the Program Memory space. In
addition, the ATmega32 features an EEPROM Memory for data storage. All three memory
spaces are linear and regular.
The ATmega32 contains 32 Kbytes On-chip In-System Reprogrammable Flash memory for pro-
gram storage. Since all AVR instructions are 16 or 32 bits wide, the Flash is organized as 16K ×
16. For software security, the Flash Program memory space is divided into two sections, Boot
Program section and Application Program section.
The Flash memory has an endurance of at least 10,000 write/erase cycles. The ATmega32 Pro-
gram Counter (PC) is 14 bits wide, thus addressing the 16K program memory locations. The
operation of Boot Program section and associated Boot Lock bits for software protection are
described in detail in
244.
ming in SPI, JTAG, or Parallell Programming mode.
Constant tables can be allocated within the entire program memory address space (see the LPM
– Load Program Memory Instruction Description).
Timing diagrams for instruction fetch and execution are presented in
ing” on page
Figure 8. Program Memory Map
“Memory Programming” on page 256
13.
“Boot Loader Support – Read-While-Write Self-Programming” on page
Application Flash Section
Boot Flash Section
contains a detailed description on Flash Program-
®
AVR
$0000
$3FFF
®
ATmega32. The AVR architec-
“Instruction Execution Tim-
ATmega32(L)
16