PI7C8150ANDE Pericom Semiconductor, PI7C8150ANDE Datasheet - Page 63
![no-image](/images/manufacturer_photos/0/5/521/pericom_semiconductor_sml.jpg)
PI7C8150ANDE
Manufacturer Part Number
PI7C8150ANDE
Description
IC PCI-PCI BRIDGE 2PORT 256-PBGA
Manufacturer
Pericom Semiconductor
Datasheet
1.PI7C8150ANDE.pdf
(111 pages)
Specifications of PI7C8150ANDE
Applications
*
Interface
*
Voltage - Supply
*
Package / Case
256-PBGA
Mounting Type
Surface Mount
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
06-0057
7
7.1
7.2
7.2.1
The device-specific P_SERR_L status register reports the reason for the assertion of
P_SERR_L. Most of these events have additional device-specific disable bits in the
P_SERR_L event disable register that make it possible to mask out P_SERR_L assertion
for specific events. The master timeout condition has a SERR_L enable bit for that event in
the bridge control register and therefore does not have a device-specific disable bit.
EXCLUSIVE ACCESS
This chapter describes the use of the LOCK_L signal to implement exclusive access to a
target for transactions that cross PI7C8150A.
CONCURRENT LOCKS
The primary and secondary bus lock mechanisms operate concurrently except when
a locked transaction crosses PI7C8150A. A primary master can lock a primary target
without affecting the status of the lock on the secondary bus, and vice versa. This means
that a primary master can lock a primary target at the same time that a secondary master
locks a secondary target.
ACQUIRING EXCLUSIVE ACCESS ACROSS PI7C8150A
For any PCI bus, before acquiring access to the LOCK_L signal and starting a series of
locked transactions, the initiator must first check that both of the following conditions are
met:
The initiator leaves the LOCK_L signal de-asserted during the address phase and asserts
LOCK_L one clock cycle later. Once a data transfer is completed from the target, the target
lock has been achieved.
LOCKED TRANSACTIONS IN DOWNSTREAM DIRECTION
Locked transactions can cross PI7C8150A only in the downstream direction, from the
primary bus to the secondary bus.
When the target resides on another PCI bus, the master must acquire not only the lock on
its own PCI bus but also the lock on every bus between its bus and the target’s bus. When
PI7C8150A detects on the primary bus, an initial locked transaction intended for a target
on the secondary bus, PI7C8150A samples the address, transaction type, byte enable bits,
and parity, as described in Section 3.5.4. It also samples the lock signal. If there is a lock
Master timeout on delayed transaction
The PCI bus must be idle.
The LOCK_L signal must be de-asserted.
Page 63 of 111
2-PORT PCI-TO-PCI BRIDGE
APRIL 2006 – Revision 1.1
PI7C8150A