646357-1 TE Connectivity, 646357-1 Datasheet - Page 6

• Manufacturer Part Number: 646357-1
• Description: HARD METRIC CONNECTOR, PLUG, 250POS
• Manufacturer: TE Connectivity
• Series: Z-PACKr
• Type: Type Er

Specifications of 646357-1

• Connector Type: Hard Metric (HM)
• Row Pitch: 2mm
• Pitch Spacing: 2mm
• No. Of Contacts: 250
• Gender: Header
• Contact Termination: Press Fit
• No. Of Rows: 8
• Contact Plating: Gold
• Rohs Compliant: Yes
• Product Type: Male
• Number Of Rows: 10
• Number Of Positions / Contacts: 250
• Termination Style: Press Fit
• Pitch: 2 mm
• Housing Material: Polyester, Glass Filled
• Contact Material: Phosphor Bronze
• Mounting Style: Through Hole
• Pcb Mounting Orientation: Vertical
• Board Mount: Fixed Board
• Module Length (mm [in]): 50.00 [1.968]
• Crosstalk Version: Standard
• Front Mating Level: Level 1
• Shielded: No
• Interface Type: 2mm HM
• Termination End Plating: Tin-Lead over Nickel
• Number Of Positions: 250
• Grounding Contact: Without
• Rows Loaded: A, B, E, F, D, C, Z, I, H
• Contact Configuration: ACTION PIN Post, Signal
• Feedthrough Post Length (mm [in]): 3.70 [0.145]
• Compactpci: No
• Contact Plating, Mating Area, Material: Gold (30)
• Contact Style: Short Tail
• Contact Base Material: Phosphor Bronze
• Connector Style: Plug
• Mating Alignment: With
• Mating Alignment Type: Multi-Purpose Center
• Housing Color: Gray
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Quantity: 11
• Lead Free Status / Rohs Status: Details

4.
4.1.
4.2.
4.3.
4.4.
Rev A
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. Test groups 1, 2, 3, 4, and 5 shall each consist of 3, 200
position male assemblies and 4, 200 position female assemblies. Test group 6 shall consist of 4,
176 position male assemblies and 4, 176 position female assemblies.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1622
6 of 10