7902401JA E2V, 7902401JA Datasheet - Page 10

• Manufacturer Part Number: 7902401JA
• Manufacturer: E2V

Specifications of 7902401JA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
(original equipment), design applications, and logistics purposes.
prepared specification or drawing.
individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
application requires configuration control and which SMD's are applicable to that system. DSCC will maintain a record of users
and this list will be used for coordination and distribution of changes to the drawings. Users of drawings covering microelectronic
devices (FSC 5962) should contact DSCC-VA, telephone [phone]
692-0547.
become available. The vendor listed herein has agreed to this drawing and a certificate of compliance (see 3.6 herein ) has
been submitted to DSCC-VA.
4.3.2 Groups C and D inspections.
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535, appendix A.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor-
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for the
6.4 Record of users. Military and industrial users should inform Defense Supply Center Columbus (DSCC) when a system
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43218-3990, or telephone 614-
6.6 Approved source of supply. An approved source of supply is listed herein. Additional sources will be added as they
DEFENSE SUPPLY CENTER COLUMBUS
a. End-point electrical parameters shall be as specified in table II herein.
b. Steady-state life test conditions, method 1005 of MIL-STD-883.
(1) Test condition C, D or E. The test circuit shall be maintained by the manufacturer under document revision level
(2) T
(3) Test duration: 1,000 hours, except as permitted by method 1005 of MIL-STD-883.
COLUMBUS, OHIO 43218-3990
control and shall be made available to the preparing or procuring activity upon request. The test circuit shall specify
the inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method
1005 of MIL-STD-883.
A
MICROCIRCUIT DRAWING
= +125°C, minimum.
STANDARD
*
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point
(method 5004)
(method 5004)
(method 5005)
electrical parameters
(method 5005)
PDA applies to subgroup 1.
MIL-STD-883 test requirements
TABLE II. Electrical test requirements. 1/ 2/
SIZE
A
MIL-STD-883, method 5005,
(in accordance with
1, 2, 3, 7, 8, 9, 10, 11
Subgroups
REVISION LEVEL
1*, 2, 3, 9
table I)
1, 2, 3
- - -
C
SHEET
79024
10