STLC5465B STMicroelectronics, STLC5465B Datasheet - Page 70

• Manufacturer Part Number: STLC5465B
• Description: Telecom ICs Multi-HDLC Sw Matrix
• Manufacturer: STMicroelectronics
• Type: Telecom IC - Variousr

Specifications of STLC5465B

• Operating Supply Voltage: 4.75 V to 5.25 V
• Operating Temperature Range: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Package / Case: PQFP-160
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STLC5465B
VIII - INTERNAL REGISTERS (continued)
MBL
SBV
VIII.3 - Input Multiplex Configuration Register 0 - IMCR0 (04)H
See definition in next Paragraph.
VIII.4 - Input Multiplex Configuration Register 1 - IMCR1 (06)H
ST(i)0 : STEP0 for each Input Multiplex i(0
ST(i)1 : STEP1 for each Input Multiplex i(0
DEL(i); : DELAYED Multiplex i(0
70/101
bit15
bit15
LP3 DEL3 ST(3)1 ST(3)0 LP2 DEL2 ST(2)1 ST(2)0 LP1 DEL1 ST(1)1 ST(1)0 LP0 DEL0 ST(0)1 ST(0)0
LP7 DEL7 ST(7)1 ST(7)0 LP6 DEL6 ST(6)1 ST(6)0 LP5 DEL5 ST(5)1 ST(5)0 LP4 DEL4 ST(4)1 ST(4)0
: Memory Bus Low impedance
: Six Bit Validation (A, E, S1/S4 bits). Global validation for 16 channels (Upstream and
MBL = 1, the shared memory bus is at low impedance between two memory cycles.
The memory bus includes Control bits, Data bits, Address bits. One Multi-HDLC is connected to
the shared memory.
MBL = 0, the shared memory bus is at high impedance between two memory cycles.
Several Muti-HDLCs can be connected to the shared memory. One pull up resistor is
recommended on each wire.
downstream).
SBV = 1, in reception, the six bit word (A, E, S1/S4) located in the same timeslot as D channel
can be received from any input timeslot; when this word is received identicaltwice consecutively,
it is stored in the external shared memory and an interrupt is generated if not masked (like the
reception of primitive from C/I channel). See “RECEIVE Command/Indicate INTERRUPT” on
page 97.
Sixteen independent detections are performed if the contents of any input timeslot is switched
in the timeslot 4n+3 of two GCI multiplexes (corresponding to DOUT4 and DOUT5) with (0 £ n
£ 7). Only the contents of D channel will be transmitted from input timeslot to GCI multiplexes.
From ISDN channels to GCI channels on page 34.
In transmission a six bit word (A, E, S1/S4) can be transmitted continuouslyto any outputtimeslot
via the TCIR. See “Transmit Command/Indicate Register TCIR (2A)H” on page 76. This word
(A, E, S1/S4) is set instead of primitive (C1, C2, C3, C4) and A, E bits received from the timeslot
4n+3 of two GCI multiplexes and the new contents of this timeslot 4n+3 must be switched on
the selected output timeslot.
SBV=0, the 16 six bit detections are not validated.
When IMTD = 0 (bit of SMCR), DEL = 1 is not taken into account by the circuit.
1/2 bit time 244ns if TDM at 2048 kHz,
1/2 bit time 122ns if TDM at 4096 kHz.
DEL (i) ST (i) 1 ST (i) 0
X
1
1
1
0
0
0
0
0
1
1
0
1
1
0
1
0
1
1
0
1
Each received bit is sampled at 3/4 bit-time without delay.
First bit of the frame is defined by Frame synchronization Signal.
Each received bit is sampled with 1/2 bit-time delay.
Each received bit is sampled with 1 bit-time delay.
Each received bit is sampled with 2 bit-time delay.
Each received bit is sampled with 1/2 bit-time advance.
Each received bit is sampled with 1 bit-time advance
Each received bit is sampled with 2 bit-time advance.
i
7).
After reset (0000)
After reset (0000)
STEP for each Input Multiplex 0/7 delayed or not
bit8
bit8
i
i
7), delayed or not.
7), delayed or not.
bit7
bit7
H
H
bit 0
bit 0