F39-EU1E Omron, F39-EU1E Datasheet - Page 600

Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com

18. Connect to the G9SX-NS@ only appropriate components or

19. OMRON is not responsible for conformity with any safety

20. Be careful not to have your fingers caught when mounting terminal

21. The service life will depend on the switching conditions. Be sure

devices complying with relevant safety standards corresponding

to the required level of safety category.

Conformity to requirements of safety category must be

determined as an entire system. It is recommended to consult an

authorized certification body regarding assessment of conformity

to the required safety level.

standards covering the customer's entire system.

blocks.

to check the actual operating conditions using the actual devices,

and make sure that the number of switching operations will not

cause performance problems.

http://www.ia.omron.com/

1. Connection with Non-contact Door Switch

2. The D40A must be used with a designated actuator and

3. Handle with Care.

4. Storage and Operating Conditions

5. Use cables with a length of less than 100 m total to connect D40A

6. Disconnect the G9SX-NS@ from the power supply when replacing

7. Do not use the D40A in a magnetic field of 1.5 mT or higher. The

8. Do not use the D40A in the water or in an environment

9. Be sure to mount a guard stopper and guide to prevent the D40A

10. Do not use the switch or actuator as a stopper. Protect the switch

G9SX-NS202-@

G9SX-NSA222-T03-@

Wire conductors between the G9SX-NS@ and the D40A

Non-contact Door Switch correctly and verify operation, before

using the system.

G9SX-NS@ Controller.

Do not drop the product or expose it to excessive vibration or

mechanical shock. The product may be damaged and may not

function properly.

Do not store or use the products under the following conditions.

1. In direct sunlight

2. At ambient temperatures not between 10 and 55°C

3. At relative humidity not between 25% and 85% or under

4. In corrosive or combustible gases

5 Where subject to vibration or mechanical shock beyond the

6. Where subject to contact with water, oil, or chemicals

7. In an atmosphere containing excessive dust, saline, or metal

8. Where iron filings or powder may fall on the product

Switches.

the D40A. Devices connected to the G9SX-NS@ may operate

unexpectedly.

D40A may not function properly.

continuously exposed to water. Water may penetrate into the

D40A. (The IP67 degree of protection for this switch means that it

has been checked for penetration of water after having been left

in water for a fixed period of time.)

Non-contact Door Switch from being subjected to impact.

and the actuator by installing a stopper. Separate the switch and

the actuator to a distance of 1 mm or more.

D1 D2 D3 D4

temperature changes that could causes condensation

rated values

powder

Total wiring length 100 m max.

Precautions for Correct Use

D40A/G9SX-NS

F39-EU1E Omron, F39-EU1E Datasheet - Page 600

F39-EU1E

Specifications of F39-EU1E

Related parts for F39-EU1E