DEA/273 FSL, DEA/273 Datasheet

RF KEYFOB, GENIE, 2BUTTON, 433MHZ

DEA/273

Manufacturer Part Number
DEA/273
Description
RF KEYFOB, GENIE, 2BUTTON, 433MHZ
Manufacturer
FSL
Datasheet

Specifications of DEA/273

External Depth
15mm
External Length / Height
50mm
External Width
37mm
Frequency
433MHz
Supply Voltage
12VDC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Important!
24v when open
12v when closed
Always make
this link
The rolling code receiver can operate on 24v AC/DC or 12v AC/DC
Note: the voltage must be selected as shown above before powering up as over voltage will
damage the system.
Procedure for receiver to learn a rolling code transmitter:
1.
2.
3.
4.
5.
6.
Voltage Selection
The maximum voltage that can be supplied to this unit is 24V AC/DC. Do not exceed this voltage.
The voltage must be selected on each individual relay PCB using the jumper links shown on the bottom right
of the relay PCB. Ensure that each PCB is set to the correct voltage before applying power.
Relay Contacts
All relay contacts are normally open volt free contacts. The maximum current switched by the relay is 1A,
Maximum voltage at the contacts 240V AC
FSL Electronics Limited, Sandholes Rd Cookstown, Co. Tyrone, N. Ireland, BT80 9AR
Tel – 028 867 66131
Ensure jumper is correctly set on receiver to set it up for learning mode.
Press the reset button on the receiver board; this
should illuminate the red LED. Hold the button until
the LED turns off (approx. 8 seconds).
Press the reset button once again; this should
illuminate the red LED again to show that the receiver
is in learning mode.
Before the LED turns off press the Ch 1 button on the
transmitter, this should cause the relay to click and
also illuminate the red LED momentarily. The receiver
should have now learned the code for Ch1, and Ch 2 is
automatically learned.
Before the LED definitively turns off, press sequentially Ch 1 of all other
transmitters if applicable, again Ch2 of these transmitters will be automatically
learned. After each stored code the relay will click.
When the last code is stored, wait for the red LED to turn off. This means that
learning mode is completed.
Rolling Code Set Up Procedures
Fax – 028 867 62414
GND +V NO NC COM COM NO ANT GND
1
2
3
CH1
RADIO MODULE
4
5
CH2
6
7
www.fslelectronics.com
8
ANT
9
LED
This link must be
made
To insure rolling
code setup
Reset button
Ch 2
Ch 1

Related parts for DEA/273

Related keywords