ADNS-3530 Avago Technologies US Inc., ADNS-3530 Datasheet - Page 15

• Manufacturer Part Number: ADNS-3530
• Description: Small Form Factor COB LED Sensor
• Manufacturer: Avago Technologies US Inc.

Specifications of ADNS-3530

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Notes on Shutdown and Forced Rest
The ADNS-3530 can be set in Rest mode through the
Configuration_Bits register (0x11). This is to allow for
further power savings in applications where the sensor
does not need to operate all the time.
The ADNS-3530 can be set in Shutdown mode by as-
serting the SHTDWN pin. For proper operation, SHTD-
WN pulse width must be at least t
widths may cause the chip to enter an undefined state.
In addition, the SPI port should not be accessed when
SHTDWN is asserted. (Other ICs on the same SPI bus can
be accessed, as long as the sensor’s NCS pin is not as-
serted.) The table below shows the state of various pins
during shutdown. After deasserting SHTDWN, a full reset
must be initiated. Wait t
port, then write 0x5A to the POWER_UP_RESET register.
Any register settings must then be reloaded.
15
WAKEUP
before accessing the SPI
SHTDWN
. Shorter pulse
Pin
NCS
MISO
SCLK
MOSI
XY_LED
MOTION
*NCS pin must be held to 1 (high) if SPI bus is shared with other de-
vices. It can be in either state if the sensor is the only device in addition
to the microcontroller.
Note: There are long wakeup times from shutdown and forced Rest.
These features should not be used for power management during
normal mouse motion.
SHTDWN active
Functional*
Undefined
Undefined
Undefined
Low Current
Undefined