W42180U2SV Seoul Semiconductor Inc, W42180U2SV Datasheet - Page 30
![LED, PURE WHT, P4, EMITT, 100-118LM](/photos/22/76/227617/149448607-40_sml.jpg)
W42180U2SV
Manufacturer Part Number
W42180U2SV
Description
LED, PURE WHT, P4, EMITT, 100-118LM
Manufacturer
Seoul Semiconductor Inc
Series
P4r
Datasheet
1.A42180R.pdf
(31 pages)
Specifications of W42180U2SV
Led Colour
White
Luminous Flux @ Test
109lm
Cct
6300K
Forward Current @ Test
350mA
Forward Current If Max
1.8A
Forward Voltage @ Test
3.25V
Power Dissipation Pd
4W
Viewing
RoHS Compliant
• Storage
• Precaution after opening packaging
• Any mechanical force or any excess vibration shall not be accepted to apply during cooling
• Please avoid rapid cooling after soldering.
• Components should not be mounted on warped direction of PCB.
• Anti radioactive ray design is not considered for the products listed here in.
• Gallium arsenide is used in some of the products listed in this publication. These products are
• This device should not be used in any type of fluid such as water, oil, organic solvent and etc.
• When the LEDs are illuminating, operating current should be decided after considering the
• LEDs must be stored to maintain a clean atmosphere. If the LEDs are stored for 3 months or
• The appearance and specifications of the product may be modified for improvement without
• Long time exposure of sunlight or occasional UV exposure will cause lens discoloration.
• The slug is connected to the anode. Therefore, we recommend to isolate the heat sink.
• Attaching LEDs, don’t use adhesives to generate organic vapor.
Attention in followed.
To avoid the moisture penetration, we recommend storing Z Power LEDs in a dry box
(or desiccator) with a desiccant . The recommended storage conditions are Temperature 5 to 30
degrees Centigrade. Humidity 50% maximum.
However LED is correspond SMD, when LED be soldered dip, interfacial separation may affect
the light transmission efficiency, causing the light intensity to drop.
process to normal temp after soldering.
dangerous if they are burned or shredded in the process of disposal. It is also dangerous to
drink the liquid or inhale the gas generated by such products when chemically disposed.
When washing is required, IPA(Isopropyl Alcohol) should be used.
package maximum temperature.
more after being shipped from SSC, a sealed container with a nitrogen atmosphere should
be used for storage.
notice.
a. Soldering should be done right after opening the package(within 24Hrs).
b. Keeping of a fraction
c. If the package has been opened more than 1week or the color of desiccant changes,
components should be dried for 10-12hr at 60±5℃
- Sealing
- Temperature : 5 ~ 40℃ Humidity : less than 30%
precaution for use
30
Document No. : SSC-QP-7-07-24 (Rev.00)
www.ZLED.com
www.ZLED.com
April. 2010
April. 2010
Rev. 10
Rev. 10