E32-R16 Omron, E32-R16 Datasheet - Page 63
![RETRO REFLECTIVE,1-1.2CM](/photos/15/83/158300/e32_sml.jpg)
E32-R16
Manufacturer Part Number
E32-R16
Description
RETRO REFLECTIVE,1-1.2CM
Manufacturer
Omron
Specifications of E32-R16
Rohs Compliant
YES
Sensing Method
Retroflective
Sensing Distance
150 mm to 1500 mm
Light Source
LED
Amplifier Type
Separate Digital Amplifier
Connection
Prewired Cable
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Safety Precautions
Refer to Warranty and Limitations of Liability.
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Do not use the product in atmospheres or environments that exceed
product ratings.
Fiber Units
● Mounting
Tightening Force
The tightening force used to mount the Fiber Unit must not be
more than the value given in Ratings/Characteristics.
Screw-mounting Model
Chemical-resistive Models
The following method is recommended to prevent the fluororesin case
from cracking when the Sensor is being secured. Be especially
careful not to crack the case when using screws to secure the Sensor.
Nuts
(attachment)
Spring mounting clip
Toothed washers
Precautions for Correct Use
Use a proper-sized wrench.
WARNING
Fiber Sensing Head
Cylindrical Model
Retaining screw
(flat head or sunken head)
(M3 max.)
Fiber Cutting Procedure
Cut a thin fiber as follows:
Connection
The Fiber Head could be broken by excessive vibration. To
prevent this, the following is effective:
Correct
Correct
• Do not excessively pull or press the Fiber Unit. Use a pulling
• Do not bend the Fiber Unit beyond the permissible bending
• Do not bend the edge of the Fiber Units
• Do not apply excess force on the Fiber Units.
(1)
(2)
(3)
(4)
A one-turn loop can
absorb vibrations.
force no higher than what is given in Ratings/Characteris-
tics.
radius given under Ordering Information.
(excluding the E32-T@R and E32-D@R).
Amplifier Unit
The fiber is shipped
loosely tightened as
shown in the figure
at the right.
Adjust the fiber to
the desired length
and then tighten it
securely.
Insert the fiber to be
cut into the E39-F4.
Finished state
(proper cutting
state)
Fiber Unit
Nylon wireholder
10 mm min.
10 mm min.
Tape
Fiber Unit
Note: Insert the fiber into the amplifier
Approx. 0.5 mm
Three holes for
standard fiber
(2.2-mm dia.)
Incorrect
Incorrect
the direction indicated by the
arrow.
Temporarily fitted
Insertion direction
Thin fiber attachment
(E39-F9)
Two holes for
thin fiber
Cutter
(E39-F4)
63