R5F61665N50FPV Renesas Electronics America, R5F61665N50FPV Datasheet - Page 532

• Manufacturer Part Number: R5F61665N50FPV
• Description: MCU FLASH 512K ROM 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of R5F61665N50FPV

• Core Processor: H8SX
• Core Size: 16/32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 92
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 11 EXDMA Controller (EXDMAC)
(5)
The DTE bit in EDMDR is written to by the CPU to control enabling and disabling of data
transfer, but may be cleared to 0 automatically by the EXDMAC due to the EXDMA transfer
status.
Conditions for DTE bit clearing by the EXDMAC include the following:
• When the specified total transfer size is completely transferred
• A transfer size error interrupt is requested, and transfer ends
• A repeat size end interrupt is requested, and transfer ends
• When an extended repeat area overflow interrupt is requested, and transfer ends
• When an NMI interrupt is generated, and transfer halts
• When an address error is generated, and transfer halts
• A reset
• Hardware standby mode
• When 0 is written to the DTE bit, and transfer halts
Writes (except to the DTE bit) are prohibited to registers of a channel for which the DTE bit is set
to 1. When changing register settings after a 0-write to the DTE bit, it is necessary to confirm that
the DTE bit has been cleared to 0.
Figure 11.21 shows the procedure for changing register settings in an operating channel.
Rev. 2.00 Oct. 21, 2009 Page 498 of 1454
REJ09B0498-0200
DTE Bit in EDMDR
Figure 11.21 Procedure for Changing Register Settings in Operating Channel
Changing register settings
Change register settings
in operating channel
changes completed
Write 0 to DTE bit
Register setting
Read DTE bit
DTE bit = 0
Yes
No
[1]
[2]
[4]
[3]
[1] Write 0 to the DTE bit in EDMDR
[2] Read DTE bit.
[3] Confirm that DTE bit = 0. If DTE bit = 1,
[4] Write the required set values to the registers.
this indicates that EXDMA transfer is in progress.