R5F61665N50FPV Renesas Electronics America, R5F61665N50FPV Datasheet - Page 199

• Manufacturer Part Number: R5F61665N50FPV
• Description: MCU FLASH 512K ROM 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of R5F61665N50FPV

• Core Processor: H8SX
• Core Size: 16/32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 92
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

7.8.2
Instructions that disable interrupts immediately after execution are LDC, ANDC, ORC, and
XORC. After any of these instructions is executed, all interrupts including NMI are disabled and
the next instruction is always executed. When the I bit is set by one of these instructions, the new
value becomes valid two states after execution of the instruction ends.
7.8.3
There are times when interrupt acceptance is disabled by the interrupt controller.
The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has
updated the mask level with an LDC, ANDC, ORC, or XORC instruction, and for a period of
writing to the registers of the interrupt controller.
7.8.4
Interrupt operation differs between the EEPMOV.B and the EEPMOV.W instructions.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the transfer is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at the end of the individual transfer cycle. The PC value saved on the
stack in this case is the address of the next instruction. Therefore, if an interrupt is generated
during execution of an EEPMOV.W instruction, the following coding should be used.
7.8.5
With the MOVMD or MOVSD instruction, if an interrupt request is issued during the transfer,
interrupt exception handling starts at the end of the individual transfer cycle. The PC value saved
on the stack in this case is the address of the MOVMD or MOVSD instruction. The transfer of the
remaining data is resumed after returning from the interrupt handling routine.
L1:
Instructions that Disable Interrupts
Times when Interrupts are Disabled
Interrupts during Execution of EEPMOV Instruction
Interrupts during Execution of MOVMD and MOVSD Instructions
EEPMOV.W
MOV.W R4,R4
BNE
L1
Rev. 2.00 Oct. 21, 2009 Page 165 of 1454
Section 7 Interrupt Controller
REJ09B0498-0200