FS-931 Digi International, FS-931 Datasheet - Page 30

• Manufacturer Part Number: FS-931
• Description: JTAG-BOOSTER FOR ELANSC520 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-931

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: AMD ElanSC520
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.1. Programming a Flash Device
Usage:
The specified file is programmed into the flash memory. Finally a complete verify
is done, if the option /VERIFY is omitted. If the verify fails, the contents of the flash
memory is written to a file with the extension DMP.
The type of the flash device is normally detected by the software. When
autodetect fails you should use the /DEVICE= option to set the right flash device.
The known devices are shown in chapter 1.7 “Supported flash devices”.
Options:
/DEVICE=devicename
The device is detected automatically by switching to autoselect mode. In case of
trouble you should select the device by using this parameter to avoid
autodetection.
/NOMAN
If you use a flash device which is identical to one of the supported parts, but is
from a different manufacturer, with this option you can suppress the comparison
of the manufacturer identification code. We recommend to use this option
together with the /DEVICE= option to avoid failures in autodetection.
/DEVICE-BASE=hhhhhh
By default a device start address of 3000000h (=48MByte) is used for accesses
to the flash device.
Default:
Abbreviation:
/OFFSET=hhhhhh
The programming starts at an offset of hhhhhh relative to the start address of the
flash device. If the offset is negative, the offset specifies an address relative to the
end of the flash device. See also option /TOP
Default:
Abbreviation:
1
30
hhhhhh=number base is hex
JTAGEL5 /P filename [optionlist]
/DEVICE-BASE=3000000
/DB=
/OFFSET=0
/O=
1
JTAGEL5d.doc